Poor contact between terminals easy causing power fault loss
2017-12-04

Now, at a time when the summer heat in summer, load rising, residential electricity consumption has many faults, I deal with residential electricity repair work, found from exposure to bad burned out terminal causing loss of power fault repair routine repair work accounted for a large proportion of crimp terminals attached great importance to the issue should be a primary power supply enterprises.

 

Many customers the isolator switch, installation process does not spill forklift fork specification, Terminal crimping wire is not very close, and routine maintenance are not in place, with the advent of winter load peak, Terminal Office overburdened, the heat burned, affecting the customer's normal electricity to residents.

 

In some measurement cargo fork sets box within of power table of wiring Terminal Department, because some construction personnel installed technology does not specification, construction in the figure easy, originally two star screws are should screwed tight of, only terminal pressure received standard screwed tight a star screws, electricity load a up, caused of trouble constantly, some Hey of measurement table meter on because received terminal pressure received tools line pile terminal manufacturers contact bad fever TKP Terminal burned, cannot continues to using, such of situation not only effects to on customer of continuous reliable power, also caused customer complaints situation of occurs , Not a small negative impact on power supply enterprise quality services.

 

In response to these developments, basic-level power supply enterprises in peak winter electricity work, focus not only on increasing the capacity of the large construction, but also for the maintenance of low voltage line equipment "little work" to be put in place, usually no matter how tight duration, to do the construction process specification, ensuring the quality of works. Low-voltage operation and maintenance personnel to open each of the metering box, control box, each electrical wiring to be done careful view and avoid sloppy, perfunctory, for customers in the electrical equipment, the line should also be carefully examined, and sometimes is tight screws the little things, you can prevent failures from occurring. Elinker said the attention prior to prevent, reduce the occurrence of power failures, with sincere and careful service make customers comfortable electricity.